Kronoa® progressive cavity pumps
Kronoa designs and manufactures progressive cavity pumps in the EU, with more than 25 years of experience. The Premium Line is built for the most demanding applications, with virtually maintenance-free operation.
Made in the EUUp to 225 m³/hUp to 36 bar

Low maintenance
Four large inspection ports and a quick disassembly system cut the time needed to remove rotor and drive shaft.
Robust drive
A double bearing support absorbs axial and radial loads; the cardan transmission with needle bearings needs no maintenance.
Standard parts
Motor and gear reducer are fully IEC standardised, so replacement parts are easy to source.
Premium Line series

S
Flanged suction pump

H
Hopper pump with feed screw, up to 40 % dry matter

Biomix
Mixing pump with hopper for substrates and digestate

V
Vertical pump for emptying tanks up to 5 m deep
Premium Line versus block design
Many progressive cavity pumps use a compact block design. The Premium Line is built differently where wear and maintenance matter most.

Kronoa Premium Line

Typical block design
| Shaft seal | Oil-lubricated cartridge seal, silicon carbide faces, up to 150 °C and 23 bar | Lubricated by the pumped liquid, carbon or ceramic faces |
|---|---|---|
| Bearing support | Double bearing support as standard | Single-row bearing; the gearbox takes the loads |
| Transmission | Modular cardan joints with needle bearings, maintenance-free | Coupling rod with pins and sleeve |
| Inspection | Four large inspection ports, rotor removable via the adapter pin | No or small inspection ports |
| Motor and reducer | Separate, IEC standardised parts | Often non-standard, only from the manufacturer |
| Rotor geometry | S type, two-stage: large solids passage, little wear | L type, one-stage: small solids passage |

Rotor geometries: the S type gives a large solids passage.
Comparison based on Kronoa's technical documentation.
Design features

Oil-lubricated mechanical seal
Cartridge seal running in oil, not in the pumped liquid, with an oil gauge for easy checks.

Cardan transmission
Needle-bearing joints, protected by a sleeve with inner textile reinforcement.

Inspection ports
Two large ports on each side, plus connections for vacuum and pressure gauges.

Biocrush
Two replaceable vanes break up fibres and large organic solids before the rotor, to prevent clogging.
Applications

Wastewater treatment: sludge and dewatered cake

Biogas: digester feed, substrates and digestate
Also for paper mills, food and general industry: bentonite, slurry, pulp and pastes.
Frequently asked questions
For viscous, abrasive or solid-laden liquids such as sludge, digestate, slurry and pastes. It delivers a steady, low-pulsation flow that is proportional to the speed.
The S series for flanged suction duty, the H series with hopper for thick products up to 40 % dry matter, Biomix for substrates and digestate, and the V series for emptying tanks up to 5 m deep. Vaikon selects the pump for your duty.
Yes. The S-type rotor and stator give a large solids passage, and the optional Biocrush vanes break up fibres and large organic solids before they reach the rotor.
Four large inspection ports, a quick disassembly system and a shaft locking device shorten maintenance. The IEC standard motor and reducer are easy to source.
Need a progressive cavity pump for sludge, digestate or slurry?
Quotation within 24 hours