Vertical slurry pumps
Schegler® Verido™ vertical slurry pumps
Vertical cantilevered slurry pumps for abrasive and corrosive liquids and slurries in sumps and pits: discharge sizes 40 to 250 mm, capacity up to 1135 m³/h and heads up to 50 m. No submerged bearings, no shaft seal and no external flushing water.

Verido™ Vertical Series
- Discharge sizes 40 to 250mm (1.5″ to 10″)
- Capacity through 1135m³/h
- Heads through 50m
Schegler designed its Verido vertical cantilevered slurry pump to handle abrasive and corrosive liquids and slurries while being submerged in sumps or pits. Its cantilever design avoids submerged bearings or a shaft seal, which ensures minimum maintenance and eliminates the need for external flushing water. Its design makes the Verido suited for continuous use in applications that require greater reliability and durability than other vertical pumps or submersible pumps can provide.
The Verido pump range is available in various lengths to cover most standard sump depths. In addition, this series offers a wide range of configuration options, which allow the pump to be tailored to a specific application. Wet-end components are available in a variety of alloys and elastomers, allowing your Schegler distributor to select the optimal combination of materials for maximum wear resistance in your application.
Verido™ Family Curves
Note: The curves above show pump performance with clean water. The curves should only be used to make a primary selection.
Why a Verido™ cantilever pump
No submerged bearings or shaft seal
The cantilever design avoids submerged bearings and a shaft seal, which keeps maintenance to a minimum.
No flushing water
No external flushing water is needed.
A length for every sump
The Verido™ range is available in various lengths to cover most standard sump depths.
Tailored configuration
A wide range of configuration options, with wet-end parts in a variety of alloys and elastomers for maximum wear resistance.
Our most used wear materials
High chrome 423 (27% Cr)
Our standard, for sharp, large and very fine particles, as in metal and plastic recycling.
Natural rubber 662 (50 Shore A)
For round, medium-sized particles, as in sand quarries.
High-chrome molybdenum 420
The wear resistance of 423 with up to a third more toughness, for dredging and sand & gravel with stones.
These are our most used materials. We offer many more, including other high-chrome alloys, stainless and duplex steels, and other rubbers and elastomers. Ask us for the right material
Frequently asked questions
A vertical slurry pump that is installed in a sump or pit. The Verido™ cantilever design avoids submerged bearings and a shaft seal, so it needs minimal maintenance and no external flushing water.
Discharge sizes from 40 to 250 mm (1.5" to 10"), capacity up to 1135 m³/h and heads up to 50 m.
The Verido™ range is available in various lengths to cover most standard sump depths. Send us the depth of your sump and we select the right length.
Yes. All Schegler® pumps are completely interchangeable with Warman® pumps and spare parts.
Need help selecting a Schegler® pump?
Share your flow rate, head and slurry data. You receive a quotation within 24 hours.